Steering Wheel Adapter?

[magic robots]

Hello! So this is my current wheel:

http://lh4.google.com/adam.helfethilliker/RopUdzf-5GI/AAAAAAAAAGA/SXCGGLnP0Ic/s800/IMG_2254.JPGx

As you can see it's a 5 bolt pattern with a relatively small radius. Is this the standard mini pattern? I'd like to change to a Sparco/Momo wheel with a quick release, so I'm trying to figure out if an adapter already exists that anybody knows about? Or if I should go another route, like pull the end of the steering column off and put on another thingamabob?

Obviously I'm not very technical. :)

Thanks y'all!

-Adam

[william75]

see post below.....

[william75]

check out my gallery...i have a Sparco wheel with a Wilwood quik-release adaptor...I made an aluminum adaptor on my lathe so i can unhook my horn wires when i remove the wheel....

[magic robots]

I saw that, it looks perfect! Nice Dash by the way .... so pretty!
So it was an easy fab?

Thanks for your reply!

-adam

[bigsexi]

Yes they do have an adapter that fits momo or sparco i got my from www.heritagegarage.com http://www.vtecminis.com/files/posted_images/user_32_momo_1191952631_198204.jpg http://www.vtecminis.com/files/posted_images/user_32_sparco_1191952689_355602.jpg

[pjku79]

I am kinda going the same route, but a little further. Does anyone know of a way to enable the steering wheel to tilt? I don't like the angle of it.

[Tavis1]

You can put in a 2" drop colum braket, that helps a lot! Just be sure to loosen the steering rack U- bolts first.

[pjku79]

alright installed my drop bracket today. wow what a difference. I didn't put it all the way down yet because I have a few wires that are short. Thanks.